• There has been a recent cluster of spammers accessing BARFer accounts and posting spam. To safeguard your account, please consider changing your password. It would be even better to take the additional step of enabling 2 Factor Authentication (2FA) on your BARF account. Read more here.

F4i tail reflector

...

square 1

855581-s3600001.jpg
 
I think I have it, I'll check later. Its yours free. I can bring it tomorrow to the Bucks meet if you want.

PM me if your comin or think up another way.:teeth
 
Haha... You'll have to take off the tail... You'll see the rivets that hold the reflector in... It looks like a 3 petal flower... I used a Dremel on mine to get rid of it... I think there is a easier way to get the rivets off though....
 
gotcha. yeah, just use a drill, slowly, till you get through the head.
 
you sure? my o2 f4i they are held on by a nut in the middle and 2 little points that come out on eaither side to hold it in the correct spot. check before you start drilling stuff
 
Irace4kimchi, did ya get'm off? I should have specified, only if its a rivet (as my 01 was), drill out the head. as said above, it might not be.
 
Back
Top