• There has been a recent cluster of spammers accessing BARFer accounts and posting spam. To safeguard your account, please consider changing your password. It would be even better to take the additional step of enabling 2 Factor Authentication (2FA) on your BARF account. Read more here.

Paint booth

dravnx

Well-known member
Joined
Dec 13, 2012
Location
santa rosa, ca
Moto(s)
Kawi 1400GTR '12
R1200RS '18
Name
Jeff
BARF perks
AMA #3018349
I want to build a paint booth for small parts. 4X4X4. It will be up against an outside wall for venting. Looking for ideas.
 
Cheap and easy or somewhat permanent? I'm somewhat partial to an EZ-up with the sides wrapped in plastic sheeting but your options are almost limitless with PVC pipe and plastic sheeting.
 
I've got some OSB and a plenty of lumber to use and want it permanent.
4'X4'X4' with outside exhaust.
 
box fans blowing over your part with heater filters to clean the air.

there are tons of hits on this with interweb searches.
 
Since it’s permanent, cover the interior with removable tear-off sides. Makes for easier clean up after multiple jobs.

Pretty common for full-size pain booths now too.
 
I built one a few years back with 3” PVC, plastic sheeting and a box fan. Pretty easy to set up and take down and fit nicely inside my garage when assembled. I used it to paint some fiberglass bodywork for my old race bike and when I was done I disassembled and stuffed on the top shelf in my garage.
 
Back
Top