900ss
Well-known member
FYI Geoffrey is quite adept at deep hole drilling if you need any info.^ not quite gun drilling but just as scary!
Do you interpolate the start hole?
-
There has been a recent cluster of spammers accessing BARFer accounts and posting spam. To safeguard your account, please consider changing your password. It would be even better to take the additional step of enabling 2 Factor Authentication (2FA) on your BARF account. Read more here.
All things machinist
- Thread starter Rmcpherson
- Start date
900ss
Well-known member
CrazyCooter, Mike knows what I mean.......
, as would any other machinists.
, as would any other machinists.
I bored. I have a half I need to hold on the large bore 9/16 deep. Then 2 inch of 1 inch 14. I roughed out everything out so I could do the critical shit at the end. I had a center in the end and did not want to puch out the bore on roughing.^ not quite gun drilling but just as scary!
Do you interpolate the start hole?
Mike95060
Work In Progress
Hey machinist peeps. I saw something new on social media. There was a company advertising to buy up all the old data from machinists part programs. NC files, CAD/CAM files all of it. Obviously they want it to train AI on. I don't know what they would offer. After 10 years programming at this company I currently have 102 GB of data in my Jobs folder. For $5k/MB I might consider it 
(In reality I left them a comment telling them to make their own data. fuckers.)
(In reality I left them a comment telling them to make their own data. fuckers.)
Last edited:
You could always sell it after you add a bunch of G0 to random places in the middle of a finish pass
littlebeast
i feel… motivated
- Joined
- Jan 26, 2008
- Location
- CA historical landmark #399
- Moto(s)
- the red witch + the green goblin
- Name
- hey you
interesting that among the ‘qualifications’ they listed, there was nothing about owning the intellectual property.
Mike95060
Work In Progress
Yup. The entire premise is wild.
Escape pod
Capable
AI will complete the task more effectively and at a lower cost. assuming you didn’t use AI.
Mike95060
Work In Progress
Yeah, sure. Robots make good welds too. When a qualified, experienced welder sets them up and keeps an eye on them.
When AI can hand a complete part to customers I will worry about my job. Until then it’s just a tool to make my life easier, someday.
ctwo
Merely Rhetorical
Taps?
